2010 Jeep Grand Cherokee Owner's Manual - Page 109

108 UNDERSTANDING THE FEATURES OF YOUR VEHICLE Lane Change Assist Tap the lever up or down once, without moving beyond the detent, and the turn signal (right or left) will flash three times then automatically turn off. High/Low Beam Switch Push the multifunction lever away from you to switch Interior Lights the headlights to high beam. Pull the multifunction lever The interior lighting consists of courtesy lights (below the toward you to switch the headlights back to low beam. instrument panel), an overhead console light (which contains both driver and passenger reading lights), readFlash-to-Pass ing lights (located above the rear doors), and a rear cargo You can signal another vehicle by lightly pulling the light. Opening a door, pressing the UNLOCK button on multifunction lever toward the steering wheel. This will the Remote Keyless Entry (RKE) transmitter or turning turn on the high beam headlights until the lever is the center of the multifunction lever to the extreme up released. position, will activate all interior courtesy lights. Headlight Time Delay Front Map/Reading Lights This feature delays turning off the headlights for 30, 60 or 90 seconds after the ignition switch is turned OFF. To These lights are mounted in the overhead console. Each activate the headlight delay, the multifunction lever must light can be turned on by pressing the recessed area of the be rotated to the "Off" position after the ignition switch lens. To turn these lights off, press the recessed area of the is turned to LOCK/ACC. Only the headlights will illuminate during this time. Refer to "Electronic Vehicle Information Center (EVIC)/Customer-Programmable Features" in "Understanding Your Instrument Panel" for further information.