2010 Jeep Grand Cherokee Owner's Manual - Page 99

98 UNDERSTANDING THE FEATURES OF YOUR VEHICLE To recall the memory settings for driver one, press MEMORY button number 1 on the driver's door, or the UNLOCK button on the RKE transmitter linked to memory position 1. To recall the memory setting for driver two, press MEMORY button number 2 on the driver's door, or the UNLOCK button on the RKE transmitter linked to memory position 2. A recall can be cancelled by pressing any of the MEMORY buttons on the drivers door during a recall (S, 1, or 2). When a recall is cancelled, the driver's seat, driver's mirror and the pedals stop moving. A delay of one second will occur before another recall can be selected. To Disable a RKE Transmitter Linked to Memory 2. Press and release MEMORY button number 1. The system will recall any memory settings stored in position 1. Wait for the system to complete the memory recall before continuing to Step 3. 3. Press and release the memory S (SET) button located on the driver's door. 4. Within five seconds, press and release MEMORY button 1 on the driver's door. 5. Within five seconds, press and release the UNLOCK button on the RKE transmitter. To disable another RKE transmitter linked to either memory position, repeat steps 1 through 5 for each RKE transmitter. NOTE: Once programmed, all RKE transmitters linked to memory can be easily enabled or disabled at one time. 1. Turn the ignition switch to the LOCK position, and Refer to "Electronic Vehicle Information Center (EVIC)/ Customer-Programmable Features" in "Understanding remove the key. Your Instrument Panel" for further information.