2010 Jeep Grand Cherokee Owner's Manual - Page 131

130 UNDERSTANDING THE FEATURES OF YOUR VEHICLE It is recommended that a new battery be placed in the Then release both the HomeLink and handheld transhand-held transmitter of the device being copied to mitter buttons. HomeLink for more efficient training and accurate If the EVIC display states "DID NOT TRAIN" repeat transmission of the radio-frequency signal. Step 3. If the signal is too weak, replace the battery in the Your vehicle should be parked outside of the garage handheld transmitter. while training. It may take up to 30 seconds or longer in rare cases. The garage door may open and close while you train. 1. Turn the ignition switch to the ON/RUN position. 2. Place the handheld transmitter 1 to 3 in (3 to 8 cm) NOTE: Some gate operators and garage door openers from the HomeLink buttons while keeping the EVIC may require you to replace Step 3 with procedures noted in the "Gate Operator/Canadian Programming" section. display in view. For optimal training, point the battery end of the hand- 4. Press and hold the just-trained HomeLink button. If held transmitter away from the HomeLink . the channel has been trained, the EVIC display will now state "CHANNEL # TRANSMIT." 3. Simultaneously, press and hold both the chosen HomeLink button and the handheld transmitter button If the EVIC display still states "CHANNEL # TRAINuntil the EVIC display changes from "CHANNEL # ING" repeat Step 3. TRAINING" to "CHANNEL # TRAINED."