2010 Jeep Grand Cherokee Owner's Manual - Page 28
2010 Jeep Grand Cherokee Manual
Page 28 highlights
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 27 NOTE: To avoid unintentional shutdowns, the system NOTE: • If an engine fault is present the vehicle will start and will disable the one time press of the REMOTE START button for two seconds after receiving a valid Remote then shut down 10 seconds later. Start request. • The park lamps will turn on and remain on during To Exit Remote Start Mode and Drive the Vehicle Remote Start mode. Before the end of 15 minute cycle, press and release the • For security, power window and power sunroof op- UNLOCK button on the RKE transmitter to unlock the eration (if equipped) are disabled when the vehicle is doors and disarm the Vehicle Security Alarm (if in the Remote Start mode. equipped). Then, prior to the end of the 15 minute cycle, • The engine can be started two consecutive times (two insert the key into the ignition switch and turn the switch 15 minute cycles) with the RKE transmitter. However, to the ON position. the ignition switch must be cycled to the ON position NOTE: before you can repeat the start sequence for a third • The ignition switch must be in the ON position in cycle. order to drive the vehicle. • For vehicles equipped with the Electronic Vehicle To Exit Remote Start Mode Without Driving the Information Center (EVIC), the message "Insert Key/ Vehicle Turn To Run" will flash in the EVIC until you insert Press and release the REMOTE START button one time or the key. Once inserted, the message "Turn To Run" allow the engine to run for the entire 15 minute cycle. will flash in the EVIC until you turn the key to run. 2