2010 Jeep Grand Cherokee Owner's Manual - Page 133

132 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 7. Return to the vehicle and press the programmed Similar to this Canadian law, some U.S. gate operators are HomeLink button twice (holding the button for two designed to "time-out" in the same manner. seconds each time). If the device is plugged in and It may be helpful to unplug the device during the cycling activates, programming is complete. process to prevent possible overheating of the garage If the device does not activate, press the button a third door or gate motor. time (for two seconds) to complete the training. If you are having difficulties programming a garage door If you have any problems or require assistance, please opener or a gate operator, replace "Programming call toll-free 1-800-355-3515 or, on the Internet at HomeLink" Step 3 with the following: www.HomeLink.com for information or assistance. 3. Continue to press and hold the HomeLink button, To program the remaining two HomeLink buttons, while you press and release ("cycle"), your handheld repeat each step for each remaining button. DO NOT transmitter every two seconds until HomeLink has successfully accepted the frequency signal. The EVIC erase the channels. display will change from "CHANNEL # TRAINING" to Gate Operator/Canadian Programming "CHANNEL # TRAINED." Canadian radio-frequency laws require transmitter signals to "time-out" (or quit) after several seconds of If you unplugged the device for training, plug it back in transmission - which may not be long enough for at this time. HomeLink to pick up the signal during programming.