2010 Jeep Grand Cherokee Owner's Manual - Page 119
2010 Jeep Grand Cherokee Manual
Page 119 highlights
118 UNDERSTANDING THE FEATURES OF YOUR VEHICLE To Set a Desired Speed When the vehicle has reached the desired speed, press down on the lever and release. Release the accelerator and the vehicle will operate at the selected speed. To Vary the Speed Setting When the Electronic Speed Control is set, you can increase speed by pushing up and holding the RESUME ACCEL lever. If the lever is continually held in the RESUME ACCEL position, the set speed will continue to NOTE: The vehicle should be traveling at a steady increase until the lever is released, then the new set speed speed and on level ground before pressing the SET lever. will be established. To Deactivate Tapping RESUME ACCEL once will result in a 1 mph A soft tap on the brake pedal, pulling the Electronic (2 km/h) speed increase. Each time the lever is tapped, Speed Control lever toward you, or normal brake presspeed increases so that tapping the lever three times will sure while slowing the vehicle will deactivate Electronic increase speed by 3 mph (5 km/h). Speed Control without erasing the set speed memory. Pressing the ON/OFF button or turning the ignition To decrease speed while the Electronic Speed Control is switch OFF erases the set speed memory. set, push down and hold the SET DECEL lever. If the lever is continually held in the SET DECEL position, the To Resume Speed set speed will continue to decrease until the lever is To resume a previously set speed, push the RESUME released. Release the lever when the desired speed is ACCEL lever up and release. Resume can be used at any reached, and the new set speed will be established. speed above 20 mph (32 km/h).