1996 Nissan Quest Owner's Manual - Page 100
1996 Nissan Quest Manual
Page 100 highlights
6. Before placing the child in the child restraint, use force to tilt the child restraint from side to side, and tug it forward to make sure it is securely held in place. 7. Check that the retractor is in the automatic locking mode by trying to pull more belt out of the retractor. If you cannot pull any more belt webbing out of the retractor, the belt is in the automatic locking mode. 8. Check to make sure the child restraint is properly secured prior to each use. If the belt is not locked, repeat steps 4 through 7. WARNING A third seat occupant should never sit at a seating location where the lap/ shoulder belt is being used to attach the child seat. Occupants should sit at locations where seat belts can be used. Remember always wear your seat belt. APD0839 APD0835 INSTALLATION ON THREEPASSENGER BENCH SEAT IN SECOND ROW A child restraint with a top tether strap may be placed at the outboard positions on the three-passenger bench seat when the bench seat is in the second row location. Once the child restraint is properly secured to the seat (see ''Installation at second and third row outboard positions'' earlier in this section), follow the directions below to attach the tether strap to the third row lap/shoulder belt tongue located on the same side of the vehicle as the child restraint. 2-67 Tethering to lap/shoulder belt tongue To attach a tether strap to a third row lap/shoulder belt: 1. Route the tether strap under the head restraint and between the head restraint supports. 2. Hook the tether strap into the large hole on the tongue of the third row lap/shoulder belt (located near the upper and lower rear corners of the vehicle). 3. Adjust the tether strap until the hook is about one foot behind the seatback.