1996 Nissan Quest Owner's Manual - Page 184
1996 Nissan Quest Manual
Page 184 highlights
Drain plug tightening torque: 22 to 29 ft-lb (29 to 39 N m) Do not use excessive force. 7. Refill the engine with a recommended oil and install the cap securely. See the ''Technical and consumer information'' section for refill capacity. 8. Start the engine. Check for leakage around the drain plug. Correct as required. 9. Turn the engine off and wait several minutes. Check the oil level with the dipstick. Add engine oil if necessary. ADI0010 4. Wipe the engine oil filter mounting surface with a clean rag. Be sure to remove any old rubber gasket remaining on the mounting surface of the engine. 5. Coat the rubber gasket on the new filter with clean engine oil. 6. Screw the oil filter in until a slight resistance is felt, then tighten additionally more than 2/3 turn. 7. Start the engine and check for leakage around the oil filter. Correct as required. 8. Turn the engine off and wait several minutes. Check the oil level. Add engine oil if necessary. CHANGING ENGINE OIL FILTER 1. Park the vehicle on a level surface and apply the parking brake. 2. Turn the engine off. 3. Loosen the oil filter with an oil filter wrench. Remove the oil filter by turning it by hand. CAUTION Be careful not to burn yourself, as the engine oil may be hot. 7-7