1996 Nissan Quest Owner's Manual - Page 130
1996 Nissan Quest Manual
Page 130 highlights
SEEK tuning This feature on your radio allows you to automatically select strong frequency stations up or down the frequency band. Press SEEK to select the next strong station up the frequency band. Press SEEK to select the next strong station down the frequency band. To change frequencies quickly, press and hold either side of the SEEK button. matically changes from stereo to monaural reception. bol appears in the display window when the rear controls are activated. Station memory operations Your radio comes equipped with six memory buttons, which are used to preset up to six AM stations and 12 FM stations. NOTE: If the vehicle's battery is disconnected, the memory buttons need to be reset. To set the memory buttons: 1. Select the desired band (AM, FM1, or FM2) by pressing the AM/FM button. 2. Tune to the desired frequency. 3. Press one of the memory buttons and hold the button in. The sound mutes out for about two seconds, then returns. That station is now held in memory on that button. Repeat the three steps above for each memory button you want to set. The memory buttons also control the rear audio controls. Push memory buttons 3 and 5 simultaneously to turn the rear audio controls on. Push them again to turn the rear audio controls off. A headphone sym3-17 ADJUSTING TONE QUALITY BASS Bass control allows you to adjust the lower, bass frequencies to your preference. Push the BASS button either or ; BASS and the setting indicator bar appear in the display window. Pressing the BASS button either or increases or decreases the level of bass, as indicated by the number of bar segments showing in the display window. Following bass adjustment, the display window shows the current setting for three seconds, then returns to the display prior to adjustment. SCAN tuning Push SCAN to enter the scan tuning mode. The radio searches up the frequency band, stopping and playing each strong frequency station for five seconds. This continues until the SCAN button is pushed a second time or a different tuning function is selected. The AM or FM1 or FM2 symbol in the display window flashes while each station is being played. TREB Treble control allows you to adjust the higher, treble frequencies to your preference. Push the TREB button either or ; TREB and the setting indicator bar appear in the display window. Pressing the TREB button either or in- AM/FM Press the AM/FM button to select the desired band: AM, FM1, or FM2. The stereo indicator shows in the display window during FM stereo reception. When the stereo broadcast signal is weak, the radio auto-