2013 Nissan Pathfinder Owner's Manual - Page 187

supplemental restraint system" section, and "Tilt/Telescopic Steering" and "Outside mirrors" in this section. During this step, do not place the ignition switch in any position other than ON. 4. Push the SET switch and, within 5 seconds, push the memory switch (1 or 2). The indicator light for the pushed memory switch will come on and stay on for approximately 5 seconds after pushing the switch. After the indicator light goes off, the selected positions are stored in the selected memory (1 or 2). If a new memory is stored in the same memory switch, the previous memory will be deleted. The indicator light will blink. After the indicator light goes off, the keyfob is linked to that memory setting. With the ignition switch placed in the OFF posibutton on the keyfob. The tion, press the driver's seat, steering wheel and outside mirrors will move to the memorized position. NOTE: If a new memory position is saved to the memory switch, the keyfob automatically re-links. 6. Move the shift selector to R (Reverse). 7. Adjust the mirror to the desired viewing position for backing up by operating the outside mirror control switch. 8. Push the SET switch and, within five seconds, push the memory switch 1 or 2 selected in step 3. ● The indicator light for the pushed memory switch will come on and stay on for approximately five seconds after pushing the switch. After the indicator light goes off, the selected mirror position is stored in the selected memory (1 or 2). 9. Turn the outside mirror control switch to R (Right). Repeat the above procedure to adjust the right mirror position and store in the selected memory. ● When the driver's seat and outside mirrors are not in the memorized position, the outside mirror will move with the initial tilt-down angle. Procedure for storing the outside mirror positions for best visibility when backing up An outside mirror position for backing up can be stored for each memory switch (1 and 2): 1. Set the parking brake. 2. Place the ignition in the ON position. (Do not start the engine.) 3. Push the memory switch 1 or 2 fully for at least one second to operate the automatic drive positioner. 4. Turn the outside mirror control switch to L (Left). 5. Depress the brake pedal. Linking a keyfob to a stored memory position Each keyfob can be linked to a stored memory position (memory switch 1 or 2) with the following procedure. 1. Follow the steps for storing a memory position. 2. While the indicator light for the memory switch being set is illuminated for 5 secbutton on the keyfob. onds, press the Seat synchronization function The seat synchronization function automatically adjusts the positions of the steering wheel and outside mirrors when the seat is adjusted using the power seat switches. 3-36 Pre-driving checks and adjustments