2013 Nissan Pathfinder Owner's Manual - Page 188

However, the steering wheel and outside mirrors will not move if the seat is adjusted over the maximum thresholds. The system considers that the steering wheel and outside mirror adjustments are not necessary because the seat may not be adjusted for the driving position. Note that the function is set to disabled as the factory default setting. The seat synchronization function operates under the following conditions: ● The ignition switch is in the ON position. ● The shift selector is in the P (Park) position. If the outside mirrors or the steering wheel reaches its maximum adjustment, the function is automatically disabled. Restart the function by selecting a previously stored seat memory position using the memory switches (1 or 2). An Intelligent Key that was previously linked to the stored seat memory can also be used to restart the function. If a seat position was not previously stored in the seat memory, restart the function by adjusting the steering wheel and outside mirrors manually for your best driving position and then drive the vehicle above 4 MPH (7 km/h). Cancel or activate seat synchronization function The shift selector must be in the P (Park) position with the ignition switch placed in the ACC position. Once the memory storage function has been restarted, you can store a memory position. See "Memory storage function" in this section. Selecting the memorized position Set the shift selector to the P (Park) position, then: ● Within 45 seconds of opening the driver's door, push the memory switch (1 or 2) or ● Place the ignition switch in the ON position and push the memory switch (1 or 2). The driver's seat, steering column, and outside mirrors will move to the memorized position with the indicator light blinking, and then the light will stay on for approximately 5 seconds. Confirming memory storage ● Place the ignition switch in the ON position and push the SET switch. If the main memory has not been stored, the indicator light will come on for approximately 0.5 seconds. When the memory has stored the position, the indicator light will stay on for approximately 5 seconds. ● If the battery cable is disconnected, or if the fuse opens, the memory storage function will be canceled and must be restarted before a stored memory position can be set again. Drive the vehicle over 25 MPH (40 km/h) to restart the memory storage function. You can also restart the memory storage function using the following procedure. 1. Connect the battery cable or replace the fuse. 2. Open and close the driver's door more than 2 times with the ignition switch in the LOCK position. ENTRY/EXIT FUNCTION This system is designed so that the driver's seat and automatic operation steering column will automatically move when the shift selector is in the P (Park) position. This allows the driver to get into and out of the driver's seat more easily. The driver's seat will slide backward and the steering column will move up: ● When the driver's door is opened with the ignition switch placed in the LOCK position. Pre-driving checks and adjustments 3-37