2013 Nissan Pathfinder Owner's Manual - Page 384

C and move 5. Press the shift selector button ᭺ the shift selector to the N (Neutral) position D while holding down the shift lock release. ᭺ The vehicle may be moved to the desired location. Replace the removed shift lock release cover after the operation. If the shift selector cannot be moved out of the P (Park) position, have a NISSAN dealer check the CVT system as soon as possible. To turn off the Overdrive off mode, push the O/D indicator light will OFF switch again. The turn off. Each time the engine is started, or when the shift selector is shifted to any position other than D (Drive), the Overdrive off mode will be automatically turned off. Fail-safe If the vehicle is driven under extreme conditions, such as excessive wheel spinning and subsequent hard braking, the fail-safe system may be activated. The MIL may come on to indicate the fail-safe mode is activated, see "Malfunction Indicator Light (MIL)" in the "Instrument and controls" section. This will occur even if all electrical circuits are functioning properly. In this case, place the ignition switch in the OFF position and wait for 10 seconds. Then push the switch back to the ON position. The vehicle should return to its normal operating condition. If it does not return to its normal operating condition, have a NISSAN dealer check the transmission and repair if necessary. WARNING If the shift selector cannot be moved from the P (Park) position while the engine is running and the brake pedal is depressed, the stop lights may not work. Malfunctioning stop lights could cause an accident injuring yourself and others. Accelerator downshift - in D position - For passing or hill climbing, depress the accelerator pedal to the floor. This shifts the transmission down into a lower gear, depending on the vehicle speed. High fluid temperature protection mode This transmission has a high fluid temperature protection mode. If the fluid temperature becomes too high (for example, when climbing steep grades in high temperature with heavy loads, such as when towing a trailer), engine power and, under some conditions, vehicle speed will be decreased automatically to reduce the chance of transmission damage. Vehicle speed can be controlled with the accelerator pedal, but the engine and vehicle speed may be limited. Overdrive (O/D) OFF switch (if so equipped) When the O/D OFF switch is pushed with the shift selector in the D (Drive) position, the light in the instrument panel illuminates. See "Overdrive off indicator light" in the "Instruments and controls" section of this manual. Use the Overdrive off mode when you need improved engine braking. Starting and driving 5-17