2015 Nissan Rogue Owner's Manual - Page 106

8. Tire pressure The tire pressure mode shows the pressure of all four tires while the vehicle is driven. The axle between the tires will also display the recommended tire pressure. When the "Tire Pressure Low Add Air" or "Flat Tire - Visit Dealer" (if so equipped) warning appears, the display can be switched to the tire button. pressure mode by pushing the The tire pressure unit can be changed in the TPMS setting under the Settings menu on the Vehicle Information Display. For additional information, refer to "Vehicle Information Display" in this section. 9. Chassis control When the Active Trace Control, Active Engine Brake, or the Active Ride Control is operated, it shows the operating condition. It also shows operating condition of hill start assist or the hill descent control. For additional information, refer to "Active Trace Control, Active Engine Brake, Active Ride Control, hill start assist or the hill descent control" in "Starting and Driving" section of this manual. Vehicle Settings The vehicle settings allows the customer to change settings for interior lights, turn signals, Intelligent Key settings, unlock settings and other vehicle settings. The vehicle settings can be changed using the , , and the ENTER buttons. Welcome light (if so equipped) The welcome light can be set to be ON or OFF. From the Vehicle Settings menu, select "Welcome Light". Use the ENTER button to turn this feature ON or OFF. Auto Room Lamp The interior lights can be set to be ON or OFF if any door is unlocked. From the Vehicle Settings menu, select "Auto Room Light". Use the ENTER button to turn this feature ON or OFF. Light Sensitivity (if so equipped) The light sensitivity can be set to illuminate earlier based on the brightness outside the vehicle. From the Vehicle Settings menu, select "Light Sensitivity". Use the ENTER button to change the sensitivity. Light Off Delay (if so equipped) The duration of the automatic headlights can be changed from 0 to 180 seconds. From the Vehicle Settings menu, select "Light Off Delay". Use the ENTER button to change the duration. 3 Flash Pass The 3 flash pass can be set to be ON or OFF. From the Vehicle Settings menu, select "3 Flash Pass". Use the ENTER button to turn this feature ON or OFF. I-Key Door Lock When this item is turned on, the request switch on the door is activated. From the Vehicle Settings menu, select "I-Key Door Unlock". Use the ENTER button to activate this function. Selective-Unlock When this item is turned on, only the driver's door is unlocked first after the door unlock operation. When the door handle request switch on the driver's or front passenger's side door is pushed to be unlocked, only the corresponding door is unlocked first. All the doors can be unlocked if the door unlock operation is performed again within 1 minute. When this item is turned to OFF, all the doors will be unlocked after the door unlock operation is performed once. From the Vehicle Instruments and controls 2-21