2015 Nissan Rogue Owner's Manual - Page 99

Operation The MIL will come on in one of two ways: ● MIL on steady - An emission control system malfunction has been detected. Check the fuel-filler cap if the LOOSE FUEL CAP warning appears in the vehicle information display. If the fuel-filler cap is loose or missing, tighten or install the cap and continue to light should turn drive the vehicle. The light off after a few driving trips. If the does not turn off after a few driving trips, have the vehicle inspected by a NISSAN dealer. You do not need to have your vehicle towed to the dealer. ● MIL blinking - An engine misfire has been detected which may damage the emission control system. To reduce or avoid emission control system damage: - do not drive at speeds above 45 MPH (72 km/h). - avoid hard acceleration or deceleration. - avoid steep uphill grades. - if possible, reduce the amount of cargo being hauled or towed. The MIL may stop blinking and come on steady. Have the vehicle inspected by a NISSAN dealer. You do not need to have your vehicle towed to the dealer. For additional information, refer to "Security systems" in this section. Slip indicator light This indicator will blink when the VDC system is operating, thus alerting the driver to the fact that the road surface is slippery and the vehicle is nearing its traction limits. You may feel or hear the system working; this is normal. The light will blink for a few seconds after the VDC system stops limiting wheel spin. indicator light also comes on when The you place the ignition switch in the ON position. The light will turn off after approximately 2 seconds if the system is operational. If the light does not come on have the system checked by a NISSAN dealer. CAUTION Continued vehicle operation without having the emission control system checked and repaired as necessary could lead to poor driveability, reduced fuel economy, and possible damage to the emission control system. Overdrive OFF indicator light The overdrive off indicator light illuminates when the overdrive off mode is selected. For additional information, refer to "Continuously Variable Transmission (CVT)" in the "Starting and driving" section of this manual. Security indicator light This light blinks when the ignition switch is placed in the OFF, LOCK or ACC (if so equipped) position. The blinking security indicator light indicates that the security systems equipped on the vehicle are operational. SPORT mode indicator light This light illuminates and then turns off when the ignition switch is placed into the ON position, and when the overdrive off mode off is selected. For additional information, refer to "Continuously Variable Transmission (CVT)" in the "Starting and driving" section of this manual. 2-14 Instruments and controls