2015 Nissan Rogue Owner's Manual - Page 243

CAUTION ● Do not force the USB device into the USB port. Inserting the USB device tilted or up-side-down into the port may damage the port. Make sure that the USB device is connected correctly into the USB port. ● Do not grab the USB port cover (if so equipped) when pulling the USB device out of the port. This could damage the port and the cover. ● Do not leave the USB cable in a place where it can be pulled unintentionally. Pulling the cable may damage the port. Refer to your device manufacturer's owner information regarding the proper use and care of the device. To connect an iPod® to the vehicle so that the iPod® can be controlled with the audio system controls and display screen, use the USB connection port located on the center console below the heater and air conditioner controls. Connect the iPod®-specific end of the cable to the iPod® and the USB end of the cable to the USB connection port on the vehicle. If your iPod® supports charging via a USB connection, its battery will be charged while connected to the vehicle with the ignition switch in the ACC or ON position. While connected to the vehicle, the iPod® can only be operated by the vehicle audio controls. To disconnect the iPod® from the vehicle, remove the USB end of the cable from the USB connection port on the vehicle, then remove the cable from the iPod®. * iPod® is a trademark of Apple Inc., registered in the U.S. and other countries. ● iPod® nano - 5th generation (firmware version 1.0.2 or later) ● iPod® nano - 6th generation (firmware version 1.1 or later) ● iPod® Touch - 2nd generation (firmware version 4.2.1 or later) ● iPod® Touch - 3rd generation (firmware version 5.1 or later) (minimum iOS 5.0 required for smartphone integration) ● iPod® Touch - 4th generation (firmware version 5.1 or later) (minimum iOS 5.0 required for smartphone integration) ● iPhone® 3G (firmware version 4.2.1 or later) ● iPhone® 3GS (firmware version 5.1 or later) (minimum iOS 5.0 required for smartphone integration) ● iPhone® 4 (firmware version 5.1 or later) (minimum iOS 5.0 required for smartphone integration) ● iPhone® 4S (firmware version 5.1 or later) (minimum iOS 5.0 required for smartphone integration) Make sure that your iPod® firmware is updated to the version indicated above. Compatibility The following models are compatible: ● iPod® Classic - 5th Generation (firmware version 1.3.0 or later) ● iPod® Classic - 6th Generation (firmware version 2.0.1 or later) ● iPod® Classic - 7th Generation (firmware version 2.0.4 or later) ● iPod® nano - 1st generation (firmware version 1.3.1 or later) ● iPod® nano - 2nd generation (firmware version 1.1.3 or later) ● iPod® nano - 3rd generation (firmware version 1.1.3 or later) ● iPod® nano - 4th generation (firmware version 1.0.4 or later) 4-66 Monitor, climate, audio, phone and voice recognition systems