2015 Nissan Rogue Owner's Manual - Page 344

5. Start the engine of the booster vehicle and let it run for a few minutes. 6. Keep the engine speed of the booster vehicle at about 2,000 rpm and start the engine of the vehicle being jump started. CAUTION Do not keep the starter motor engaged for more than 10 seconds. If the engine does not start right away, place the ignition switch in the OFF position and wait 3 to 4 seconds before trying again. WCE0054 WARNING Always follow the instructions below. Failure to do so could result in damage to the charging system and cause personal injury. 1. If the booster battery is in another vehicle, position the two vehicles to bring their batteries near each other. Do not allow the two vehicles to touch. 2. Apply the parking brake. Move the shift lever to P (Park). Switch off all unnecessary electrical systems (lights, heater, air conditioner, etc.). 3. Ensure the vent caps are level and tight. 4. Connect the jumper cables in the sequence A,᭺ B,᭺ C,᭺ D ). illustrated (᭺ 7. After starting the engine, carefully disconnect the negative cable and then the positive cable. CAUTION ● Always connect positive (ϩ) to positive (ϩ) and negative (Ϫ) to body ground (for example, strut mounting bolt, engine lift bracket, etc.) - not to the battery. ● Make sure the jumper cables do not touch moving parts in the engine compartment and that the cable clamps do not contact any other metal. In case of emergency 6-11