2006 Subaru Outback Owner's Manual - Page 185

5-12 Audio Press the "RPT" button Press the " " or " " side of the SEEK/SCAN button Press the " " button Select the radio mode Turn off the power of the audio equipment. Turn the ignition switch to the "OFF" position. Scan ward beginning with the track preceding the currently selected one. After all tracks on the disc has been scanned, normal playback mode is restored. To cancel a scan, press the " " or " " side of the button again. To eject a disc from the player NOTE SEEK SCAN The scan mode will be cancelled if you perform any of the following operations: Press the "RPT" button Press the "RDM" button Press the " " button Press the " " or " " side of the TUNE/TRACK button Select the radio mode Turn off the power of the audio equipment. Turn the ignition switch to the "OFF" position. 500237 When a disc is being played back or when a disc is in the player, press the eject button " ". The disc will be ejected. NOTE 500232 The scan mode lets you listen to the first 10 seconds of each track on the disc in succession. Press the " " side of the SEEK/SCAN button to start scanning through all tracks upward beginning with the track following the currently selected one. Press the " " side of the button to start scanning through all tracks down- Avoid driving the vehicle with a CD sticking out, because vibration might make it fall out. If the disc is left ejected for more than approximately 15 seconds after the ignition switch is turned to the "OFF" position, a disc protection function will operate, automatically reloading the disc. In this case, the disc is not played.