2006 Subaru Outback Owner's Manual - Page 330

Appearance care 10-3 NOTE Be careful not to damage brake hoses, sensor harnesses, and other parts when washing suspension components. Using a warm water washer Keep a good distance of 12 in (30 cm) or more between the washer nozzle and the vehicle. Do not wash the same area continuously. If a stain will not come out easily, wash by hand. Some warm water washers are of the high temperature, high pressure type, and they can damage or deform the resin parts such as mouldings, or cause water to leak into the vehicle. mended that a coat of wax be applied at least once a month, or whenever the surface no longer repels water. If the appearance of the paint has diminished to the point where the luster or tone cannot be restored, lightly polish the surface with a fine-grained compound. Never polish just the affected area, but include the surrounding area as well. Always polish in only one direction. A No. 2000 grain compound is recommended. Never use a coarse-grained compound. Coarser grained compounds have a smaller grainsize number and could damage the paint. After polishing with a compound, coat with wax to restore the original luster. Frequent polishing with a compound or an incorrect polishing technique will result in removing the paint layer and exposing the undercoat. When in doubt, it is always best to contact your SUBARU dealer or an auto paint specialist. is left on too long, it may be difficult to clean off. Do not use soap containing grit to clean the wheels. Be sure to use a neutral cleaning agent, and later rinse thoroughly with water. Do not clean the wheels with a stiff brush or expose them to a high-speed washing device. Clean the vehicle (including the aluminum wheels) with water as soon as possible when it has been splashed with sea water, exposed to sea breezes, or driven on roads treated with salt or other agents. Waxing and polishing Always wash and dry the vehicle before waxing and polishing. Use a good quality polish and wax and apply them according to the manufacturer's instructions. Wax or polish when the painted surface is cool. Be sure to polish and wax the chrome trim, as well as the painted surfaces. Loss of wax on a painted surface leads to loss of the original luster and also quickens the deterioration of the surface. It is recom- NOTE Be careful not to block the windshield washer nozzles with wax when waxing the vehicle. Cleaning aluminum wheels Promptly wipe the aluminum wheels clean of any kind of grime or agent. If dirt