3Com 3CRWE50194 User Guide - Page 23

3 Basic Installation Figure 8 Connecting the Gateway to an Ethernet Network 6V _+ Cable/DSL Reset 3X 2X 1X 3X 2X 1X Ethernet port _ Powering Up the Gateway 1 Plug the cable of the included power adapter into the power adapter socket located on the back panel of the gateway (refer to "Power Adapter Socket" in Table 2 on page 9). 2 Attach the appropriate plug adapter for your country to the power adapter. 3 Plug the power adapter into a standard electrical wall socket. Setting Up Computers for Wireless Networking Basic procedures are given below for setting up Windows-based and Macintosh-based computers for wireless communication with the gateway. Refer to the documentation that comes with your wireless network interface card for more details about setting up your desktop or notebook computer for a wireless connection. Windows If you are using a Windows-based computer, use the following procedure to change your TCP/IP settings, and then select the ESSID (Extended Service Set IDentification). 1 From the desktop, click Start, and then select Settings, Control Panel, and Network. 2 From the Network control panel, select TCP/IP. 15