Apple M8840LL/A Setup Guide - Page 20
See the information that came with your monitor for the location of the power button.
UPC - 718908440841
View all Apple M8840LL/A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
To connect your Macintosh to a centralized 10/100 twisted-pair network, follow these steps: 1 Plug one end of an RJ-45 twisted-pair cable into the Ethernet port on your Macintosh. 2 Plug the other end of the cord into an RJ-45 wall outlet or external hub that is connected to a twisted-pair Ethernet network. Ethernet port (10/100 twistedpair Ethernet) RJ-45 wall plate 10/100 Ethernet hub or switch 10/100 twisted-pair Ethernet cable Note: The cable length from your computer's Ethernet port to a network hub should not exceed 100 meters. Check with your network administrator if you have a question about the cable length from your computer to the network hub. After you start up the computer, you need to configure the software for your network connection. Your network administrator can provide the necessary information. You can also get help configuring your network software using the electronic documentation that came with your computer. Turning the Computer On To turn your computer on for the first time, follow these steps: 1 Turn on the monitor. See the information that came with your monitor for the location of the power button. On newer Apple monitors, the power button, which can also turn on the computer, is located on the front. The power indicator light may not come on until you turn on the computer in the next step. Note: Some monitors turn on automatically when you start up the computer and turn off automatically when you shut the computer down. You turn other monitors on or off separately. 20 Chapter 1