Brother International EF4-B561 Service Manual - Page 19
Procedures
View all Brother International EF4-B561 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Procedures Q'ty of screw 8 Insert needles all the way into needle clamp Q and tighten screws. 9 Install needle plate ® . 2 10 Check part ® on the over looper driving lever and see whether the machine is for standard use (S) or high-lift use (H). 11 Standard needle for adjustment is as follows. • In case of the twin-needle, use the left needle. • In case of the safety stitch, use the hemming needle. 0 0 ® + The below items of and Safety Stitch should be taken simultaneously. 12 In case of sewing machines made to the standard specifications, adjust the distance between the needle point and the top of needle plate to 1 1 mm when the needle is up highest. The sewing machines of the high-lift specifications must be adjusted to a distance of 11.5mm between them. Standard specifications I anal 1 1 .5mm High-lift Specifications CS) 13 Safety Stitch Turn the pulley slowly, lower needle slightly into needle plate and adjust it so needles will be in the center of needle plate slot, by turning needle bar. 13 In case of the single needle, tighten needle bar clamp with screw. In case of the twin-needle, temporarily fasten needle bar clamp with screw. In case of the safety stitch, after make sure needle should be in the center of needle plate slot, tighten needle bar clamp with screw. Safety stitch (B581) - 17 -