Brother International Innov-is 1250D Operation Manual - Page 193
mounting base, and then fit the needle plate
View all Brother International Innov-is 1250D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 193 highlights
Use the enclosed disc-shaped screwdriver to j loosen the two screws on the needle plate. Turn the handwheel to check that the feed dogs move smoothly and do not contact the edges of the slots in the needle plate. Note z Be careful not to drop the removed screws in the machine. Slightly lift up the needle plate, cut any tangled k threads, and then remove the needle plate. Remove the fabric and threads from the needle plate. a Correct position of feed dogs b Incorrect position of feed dogs Note z Be careful not to drop the removed screws in the machine. Insert the bobbin case so that the S mark on p the bobbin case aligns with the z mark on the machine. If the fabric cannot be removed, even after completing these steps, contact your nearest authorized service center. Remove any threads in the race and around l the feed dogs. a 5 b a b Turn the handwheel to raise the feed dogs. m Align the two screw holes in the needle plate n with the two holes at the needle plate mounting base, and then fit the needle plate onto the machine. • Align the S and z marks. Lightly finger-tighten the screw on the right o side of the needle plate. Then, use the disc- shaped screwdriver to firmly tighten the screw on the left side. Finally, firmly tighten the screw on the right side. a S mark b z mark c Bobbin case • Make sure that the indicated points are aligned before installing the bobbin case. Troubleshooting 191