Brother International Innov-is 1250D Operation Manual - Page 197
List of symptoms
View all Brother International Innov-is 1250D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 197 highlights
List of symptoms Symptom Probable Cause Remedy Reference The machine is not turned on. Turn on the machine. page 19 The "Start/Stop" button was not pressed. Press the "Start/Stop" button. page 53 The sewing machine does not operate. The presser foot lever is raised. The "Start/Stop" button was pressed, even though the foot controller is connected. Lower the presser foot lever. Do not use the "Start/Stop" button when the foot controller is connected. To use the "Start/Stop" button, disconnect the foot controller. page 52 page 53 The bobbin winder shaft is pushed Move the bobbin winder shaft to the to the right. left. page 28 The needle is incorrectly installed. Correctly install the needle. The needle clamp screw is loose. Use the screwdriver to firmly tighten the screw. page 42 The needle is bent or blunt. Replace the needle. The combination of fabric, thread and needle is not correct. Select a thread and needle that are appropriate for the type of fabric being sewn. page 41 The presser foot that is used is not Attach the presser foot that is 5 appropriate for the type of stitch appropriate for the type of stitch that page 70 that you wish to sew. you wish to sew. The upper thread tension is too tight. Loosen the upper thread tension. page 59 The needle breaks. The fabric is pulled too much. The spool is incorrectly installed. Lightly guide the fabric. Correctly install the spool. - page 31 The area around the hole in the Replace the needle plate. Contact needle plate is scratched, or has a your retailer or the nearest authorized - burr on it. service center. The area around the hole in the Replace the presser foot. Contact presser foot is scratched, or has a your retailer or the nearest authorized - burr on it. service center. The bobbin case is scratched, or has a burr on it. Replace the bobbin case. Contact your retailer or the nearest authorized service center. - A bobbin designed specifically for this machine is not used. Incorrect bobbins will not work properly. Only use a bobbin designed specifically for this machine. page 25 Troubleshooting 195