Brother International Innov-is 1250D Operation Manual - Page 32

GETTING READY CAUTION ● Be sure to install the bobbin so that the thread unwinds in the correct direction, otherwise the thread may break or the thread tension will be incorrect. Note z Make sure that the thread is correctly inserted through the tension-adjusting spring of the bobbin case. If it is not inserted correctly, reinsert the thread. Memo z The order that the bobbin thread should be passed through the bobbin case is indicated by marks around the bobbin case. Be sure to thread the machine as indicated. While lightly holding down bobbin with your g right hand as shown, guide the thread through the slit (1 and 2). • At this time, check that the bobbin easily rotates counterclockwise. Then, pull the thread toward you to cut it with the cutter (3). 1 a Tension-adjusting spring Reattach the bobbin cover. h Insert the tab in the lower-left corner of the bobbin cover, and then lightly press down on the right side. a Slit b Cutter (Cut the thread with the cutter.) X The bobbin threading is finished. Next, thread the upper thread. Continue with the procedure in "Upper Threading" (page 31). Memo z You can begin sewing without pulling up the bobbin thread. If you wish to pull up the bobbin thread before starting to sew, pull up the thread according to the procedure in "Pulling up the bobbin thread" (page 39). 30