Brother International Innov-is 1250D Operation Manual - Page 31
Installing the bobbin
View all Brother International Innov-is 1250D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Remove the spool for the bobbin thread from q the spool pin, and then close the top cover. Press ("Needle Position" button) once or a twice to raise the needle, and then raise the presser foot lever. Memo Turn off the sewing machine. z When the sewing machine is started or the b 1 handwheel is turned after winding the Slide the bobbin cover latch to the right. bobbin, the machine will make a clicking c sound; this is not a malfunction. Installing the bobbin Install the bobbin wound with thread. CAUTION ● Use a bobbin that has been correctly wound with thread, otherwise the needle may break or the thread tension will be incorrect. a Bobbin cover b Latch X The bobbin cover opens. Remove the bobbin cover. d Hold the bobbin with your right hand and hold e the end of the thread with your left. ● The bobbin was designed specifically for this sewing machine. If bobbins from other models are used, the machine will not operate correctly. Use only the included bobbin or bobbins of the same type (part code: SA156, SFB (XA5539-151)). Actual size 11.5 mm (7/16 inch) This model Other model • Be careful not to drop the bobbin. Insert the bobbin with your right hand so that f the end of the thread is on the left, and then, after pulling the thread firmly around the tab with your left hand as shown, lightly pull the thread to guide it through the slit. 1 a Tab Winding/Installing the Bobbin 29