Brother International Innov-is 1250D Operation Manual - Page 30

GETTING READY While holding the thread with your left hand, k wind the thread that was pulled out clockwise around the bobbin five or six times with your right hand. Press ("Start/Stop" button) once to start n winding the bobbin. When the foot controller is plugged in, press down on the foot controller. Note z Make sure that the thread between the spool and the bobbin is pulled tight. z Be sure to wind the thread clockwise around the bobbin, otherwise the thread will become wrapped around the bobbin winder shaft. Pass the end of the thread through the guide l slit in the bobbin winder seat, and then pull the thread to the right to cut it. 1 a Guide slit in bobbin winder seat (with built-in cutter) X The thread is cut to a suitable length. a "Start/Stop" button • When the bobbin winding becomes slow, press ("Start/Stop" button) once to stop the machine. When the foot controller is plugged in, remove your foot from the foot controller. CAUTION ● When the bobbin winding becomes slow, stop the machine, otherwise the sewing machine may be damaged. Use scissors to cut the end of the thread o wound around the bobbin. CAUTION ● Be sure to cut the thread as described. If the bobbin is wound without cutting the thread using the cutter built into the slit in the bobbin winder seat, the thread may become tangled in the bobbin and the needle may bend or break when the bobbin thread starts to run out. Slide the bobbin winder shaft to the left, and p then remove the bobbin from the shaft. Slide the sewing speed controller to the right m to increase the bobbin winding speed and slide to left to decrease. Memo z If the bobbin winder shaft is set to the right side, the needle will not move. (Sewing is impossible.) a Speed controller 28