Brother International PR-1000 Upgrade KIT CW Operation Manual PRCW1 - Page 13

CREATING CUTWORK Turning On the Machine 2 a Turn the machine on again. → The following messages appear. b Check the information in the message, and then touch . Note • Check that the cutwork needles are installed. Also, periodically clean the needle plate, hook and bobbin case after using the machine. • This machine is equipped with a memory feature so that, if the machine is turned off while it is being operated, it will resume the stopped operation when it is turned on again. However, if the Cutwork mode is turned off during an operation, this feature will be disabled. For details on this memory feature, refer to "Resume Embroidering After Turning Off the Machine" in chapter 3 of your machine's Operation Manual. Memo • Once the Cutwork mode has been turned on, the machine starts in Cutwork mode each time it is turned on until Cutwork mode is turned off. Importing a Pattern 2 a Insert the CD-ROM1 (for machines) into the computer's CD-ROM drive. Copy the "patterns" folder to the USB media. b Insert the USB media into the primary (top) USB port on the machine. → The machine enters Cutwork mode. 12