Campbell Scientific CSAT3 CSAT3 3-D Sonic Anemometer - Page 17
TABLE 5-1., CSAT3 Power, TABLE 5-2., CSAT3 SDM Output to a, CR3000, CR5000, and CR9000X Datalogger,
View all Campbell Scientific CSAT3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
CSAT3 Three Dimensional Sonic Anemometer CAUTION The CSAT3 electronics box contains unique calibration information for its respective sensor head. Do not mismatch CSAT3 sensor heads and electronics. Doing so will result in erroneous wind and speed of sound measurements. NOTE Before extending the SDM signal cable, read Appendix D. NOTE Short haul modems, wire or fiber optic, may be used to lengthen the RS-232 communications cable. Short haul modems do not include an RTS signal. The CSAT3's RS-232 drivers can be asserted by a software setting in the CSAT3. This setting will always power the RS-232 drivers, independent of the RTS line. Spark gaps (model 6536 and 6361) may be required to protect against transients when using wire short haul modems. Spark gap protection is not needed with fiber optic short haul modems. TABLE 5-1. CSAT3 Power Battery Terminal Description Color Pin Positive 12 Vdc Red A Negative Power Reference Black B TABLE 5-2. CSAT3 SDM Output to a CR3000, CR5000, and CR9000X Datalogger Channel SDM-C1 SDM-C2 SDM-C3 G G Description SDM Data SDM Clock SDM Enable Digital Ground Shield Color Pin Green D White C Brown E Black F Clear nc TABLE 5-3. CSAT3 SDM Output to a CR1000, CR800/850, CR23X and CR10(X) Datalogger Channel C1 C2 C3 G G Description SDM Data SDM Clock SDM Enable Digital Ground Shield Color Pin Green D White C Brown E Black F Clear nc 9