Canon EOS Rebel T2 EOS Rebel T2 manual - Page 51

• Shutter Type Electronically controlled focal-plane shutter Shutter speeds 1/4000 - 30 sec. in 1/2-stop increments, bulb, X sync at 1/125 sec. Shutter release Soft touch electromagnetic release (safety release lock possible) Self-timer Shoot after 10 sec. delay Remote control Remote Controller RC-1/RC-5 (DATE Model only) • Flash Built-in flash E-TTL II autoflash, FE lock possible Guide No. 13 (ISO 100, in meters), 39 (ISO 100, in feet) Recycling time: Approx. 2 sec. Flash coverage: 28 mm lens angle covered Red-eye reduction: Lamp External EOS-dedicated flash ...E-TTL II autoflash • Film transport Film loading Automatic prewind Film advance modes Single-frame/continuous shooting Continuous shooting speeds (approx.) ...One Shot AF: 3 fps, AI Servo AF: 2.5 fps Film rewind Automatic. Mid-roll rewind • Custom Functions.........6 • Date imprinting (DATE Model only)...Automatic calendar to 2099 • Power source Two CR2 lithium batteries • Dimensions (W x H x D) ..130 x 90 x 64 mm/5.1 x 3.5 x 2.5 in • Weight 365 g/12.7 oz (body only) • All the specifications above are based on Canon's testing and measuring standards. • Specifications and physical appearance are subject to change without notice. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Do not make any changes or modifications to the equipment unless otherwise specified in the instruction manual. If such changes or modifications should be made, you could be required to stop operation of the equipment. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Consult the dealer or an experienced radio/TV technician for help. Complies with the Canadian ICES-003 class B specifications. Respecte les exigences de la class B de la NMB-003 du Canada. The CE Mark is a Directive conformity mark of the European Community (EC) 51