Canon VB-M740E Network Camera VB-R11VE/VB-R11/VB-R10VE/VB-M641VE/VB-M641V/VB-M - Page 128
Manual, ecurity Protocol] Is, et to [E, P] or [E, P and AH]
View all Canon VB-M740E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
Manual [IPsec Set] Set whether IPv4 or IPv6 will use or will not use IPsec sets. [IPsec Mode] Select the IPsec mode. [Destination IPv4 Address], [Destination IPv6 Address] Enter the IP address of the connection destination. [Source IPv4 Address], [Source IPv6 Address] Enter the IP address of the source. [Security Protocol] Select the IPsec protocol. If [ESP] is selected, enter only the setting items relating to ESP. If [AH] is selected, enter only the setting items relating to AH. If [ESP and AH] is selected, enter all setting items. [Security Gateway IPv4 Address], [Security Gateway IPv6 Address] Enter the IP address of the security gateway if [IPsec Mode] is set to [Tunnel Mode]. [Destination Subnet Mask Length] (IPv4), [Destination Prefix Length] (IPv6) Enter the subnet mask (IPv4) or prefix length (IPv6) when [IPsec Mode] is set to [Tunnel Mode]. When [Security Protocol] Is Set to [ESP] or [ESP and AH] [SA ESP Encryption Algorithm] to [SA ESP SPI (inbound)] must be set. [SA ESP Encryption Algorithm] Set the ESP encryption algorithm to suit the encryption algorithm supported by the device to connect to. Normally [AES] or [3DES] is recommended. [SA ESP Authentication Algorithm] Set the ESP authentication algorithm to suit the authentication algorithm supported by the device to connect to. 128