Canon VB-M740E Network Camera VB-R11VE/VB-R11/VB-R10VE/VB-M641VE/VB-M641V/VB-M - Page 87

Set Audio Input/Output [Video and Audio] > [Audio Settings] R11 M641 M741 Settings for audio input from the microphone connected to the camera and audio output from the Viewer. The output sound clip used when an event is triggered can also be registered. This [Audio Settings] submenu is common with the [Audio Settings] submenu found in the [Event] menu. Settings configured in any page will be reflected in the other pages. Important • Video and audio can be distributed to up to 30 clients. However, when there are many clients or they are connected to the camera over an SSL connection, the video frame rate may slow down and the sound may drop out if audio reception from the camera is enabled. • The video and audio may not be synchronized. • If the [Input Volume] or [Echo Canceller] setting is changed after setting volume detection (P. 107) or scream detection (P. 108), check the detection setting again. • The audio may be temporarily interrupted, depending on the performance of the computer and the network environment. • The audio may be interrupted if anti-virus software is enabled. • Communication may be temporarily interrupted, cutting off the audio, if the LAN cable is unplugged and plugged in again. If this occurs, reconnect from the Viewer. • The volume, sound quality, etc., may change depending on the characteristics of the microphone used. • Use a speaker with an amplifier to connect to the camera ("Installation Guide" > "Audio Input/Output Terminals"). Setting Page 4 General Sound Set the audio input/output volume, echo cancellation and microphone type. [Input Volume] Enter the input volume from the microphone connected to the camera. This can be set when [Server] > [Audio Server] > [Audio Transmission from the Camera] (P. 92) is set to [Enable]. [Output Volume] Enter the output volume from the Viewer to the speaker connected to the camera. This can be set when [Server] > [Audio Server] > [Audio Reception from Viewer] (P. 92) is set to [Enable]. [Echo Canceller] Select to enable or disable the Echo Canceller for suppressing echoes that occur between the microphone and speaker. This can be set when [Server] > [Audio Server] (P. 92) is set to the following. • [Audio Transmission from the Camera] is set to [Enable] • [Audio Reception from Viewer] is set to [Enable] Important Use of the Echo Canceller may affect audio quality and volume. Use it when necessary to suit the installation environment and camera usage. [Audio Input] Select the type of microphone connected to the camera. 87