Cisco WRV200 User Guide - Page 10

Chapter 4 Product Overview Chapter 4: Product Overview Front Panel The Router's LEDs are located on the front panel of the Router. Front Panel POWER (Green) The Power LED lights up when the Router is powered on. DMZ (Green) The DMZ LED lights up when the Router has an available DMZ port. If the LED is flashing, the Router is sending or receiving data over the DMZ port. INTERNET (Green) The Internet LED lights up when the Router is connected to your cable or DSL modem. If the LED is flashing, the Router is sending or receiving data over the Internet port. WIRELESS (Green) The Wireless LED lights up whenever there is a successful wireless connection. If the LED is flashing, the Router is actively sending or receiving data over the wireless network. 1-4 (ETHERNET) (Green) These four LEDs correspond to the Router's four Ethernet ports. If the LED is continuously lit, the Router is connected to a device through the corresponding port (1, 2, 3, or 4). If the LED is flashing, the Router is actively sending or receiving data over that port. Back Panel The Router's ports and Reset button are located on the back panel of the Router. Back Panel POWER The Power port is where you will connect the AC power cable. RESET The Reset button has two functions. • If pressed for one second, the Reset button causes a warm reboot-the Router restarts without losing any of the current configuration settings. • If pressed for approximately 15 seconds, the Reset button resets the Router's factory defaults. You can also restore the factory defaults from the Administration > Factory Defaults screen of the Router's Web-based Utility. INTERNET The Internet port connects to your cable or DSL modem. 1-4 (ETHERNET) The four Ethernet ports connect to your PCs and other network devices. Wireless-G VPN Router with RangeBooster