Compaq BL20p Installation Guide - Page 34
Powering Up the Server Blade, Power On/Standby button - power supply
UPC - 720591771058
View all Compaq BL20p manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Installing the Server Blade and Options Powering Up the Server Blade To install a server blade in the server blade enclosure, refer to the "Installing a Server Blade" section in this chapter. Server blades are set to power up automatically. If you changed this setting, use one of the following methods to power up the server blade: • Power On/Standby button - A momentary press initiates a power-up request. The system detects if power is available to power on the server blade. - A long press, 5 or more seconds, initiates a power-up override. The system is forced to power up the server blade without detecting available power. CAUTION: Always observe iLO alerts before initiating a power-up override to prevent a hot-plug power supply fault and possible loss of system power. NOTE: You may choose to perform a power-up override to power up a server blade and to override the power-up request function when the management modules are not in use and when you know that sufficient power is available. • Virtual power button features through the iLO remote console - A momentary power-up selection initiates a power-up request. The system detects if power is available to power up the server blade. - A hold power-up selection initiates a power-up override. The system is forced to power up the server blade without detecting available power. For more information about iLO, refer to Chapter 3, "Configuring and Deploying Server Blades." 2-20 Compaq ProLiant BL20p Server Blade Setup and Installation Guide