Compaq ProLiant 6500 Compaq Parallel Database Cluster Model PDC/O2000 for Orac - Page 103

Cluster Software Components 3-3 Compaq System Configuration Utility The SmartStart and Support Software CD also contains the Compaq System Configuration Utility. This utility is the primary means to configure hardware devices within your servers, such as I/O addresses, boot order of disk controllers, and so on. For information about the System Configuration Utility, see the Compaq Server Setup and Management pack. Compaq Array Configuration Utility The Compaq Array Configuration Utility, found on the Compaq SmartStart and Support Software CD, is used to configure the hardware aspects of any disk drives attached to an array controller, including the non-shared drives in the servers and the shared drives in the Compaq StorageWorks RAID Array 4000s (RA4000 Arrays) or Compaq StorageWorks RAID Array 4100s (RA4100 Arrays). The Array Configuration Utility also allows you to configure RAID levels and to add disk drives or RA4000/RA4100 Arrays to an existing configuration. For information about the Array Configuration Utility, see the Compaq StorageWorks RAID Array 4000 User Guide or the Compaq StorageWorks RAID Array 4100 User Guide. Fibre Channel Fault Isolation Utility The SmartStart and Support Software CD also contains the Fibre Channel Fault Isolation Utility (FFIU). The FFIU verifies the integrity of a new or existing redundant Fibre Channel Arbitrated Loop (FC-AL). This utility provides fault detection and help in locating a failing device on a redundant FC-AL. For more information about the FFIU, see the Compaq SmartStart and Support Software CD.