Dell C9000 Line Cards Networking C9010 Getting Started Guide - Page 13

Installing the Cable Management System

Get Dell C9000 Line Cards PDF manuals and user guides View all Dell C9000 Line Cards manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

WARNING: To prevent bodily injury when mounting or servicing this unit in a rack, take special precautions to ensure that the system remains stable. The following guidelines are provided to ensure your safety: • If your chassis is the only unit in the rack, mount it at the bottom of the rack. • When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component at the bottom of the rack. • If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack. • If the chassis is shipped with blanks, remove the blanks from each RPM, line card, fan module and PSU slot before lifting the chassis. 1. (Optional) The C9010 chassis is designed to fit into a rack enclosure with the front door closed. If you plan to use cable management brackets (Installing the Cable Management System ) and close the front door, re-position and fasten the front rack posts 6.5 inches (165 mm) back towards the rear of the rack to leave space for the brackets. 2. Determine the height at which you want to mount the chassis in the rack. Installing the Hardware 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
WARNING: To prevent bodily injury when mounting or servicing this unit in a rack, take special
precautions to ensure that the system remains stable. The following guidelines are provided to
ensure your safety:
•
If your chassis is the only unit in the rack, mount it at the bottom of the rack.
•
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with
the heaviest component at the bottom of the rack.
•
If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing
the unit in the rack.
•
If the chassis is shipped with blanks, remove the blanks from each RPM, line card, fan module
and PSU slot before lifting the chassis.
1.
(Optional) The C9010 chassis is designed to fit into a rack enclosure with the front door closed. If
you plan to use cable management brackets (
Installing the Cable Management System
) and close
the front door, re-position and fasten the front rack posts 6.5 inches (165 mm) back towards the rear
of the rack to leave space for the brackets.
2.
Determine the height at which you want to mount the chassis in the rack.
Installing the Hardware
13