Dell DSS 1510 Lifecycle Controller v2.40.40.40 Users Guide - Page 76
Entering System Setup, Responding to error messages, Using the system setup navigation keys
View all Dell DSS 1510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
NOTE: The system supports only BIOS boot mode. 1. From the System Setup Main Menu, click Boot Settings, and select Boot Mode. 2. Select the UEFI boot mode you want the system to boot into. CAUTION: Switching the boot mode may prevent the system from booting if the operating system is not installed in the same boot mode. 3. After the system boots in the specified boot mode, proceed to install your operating system from that mode. NOTE: Operating systems must be UEFI-compatible to be installed from the UEFI boot mode. DOS and 32-bit operating systems do not support UEFI and can only be installed from the BIOS boot mode. NOTE: For the latest information about supported operating systems, go to Dell.com/ossupport. Entering System Setup 1. Turn on, or restart your system. 2. Press F2 immediately after you see the following message: F2 = System Setup If your operating system begins to load before you press F2, wait for the system to finish booting, and then restart your system and try again. Responding to error messages If an error message is displayed while the system is booting, make a note of the message. For more information, see System Error Messages. NOTE: After installing a memory upgrade, it is normal for your system to display a message the first time you start your system. Using the system setup navigation keys Table 16. Using the system setup navigation keys Keys Up arrow Down arrow Spacebar Action Moves to the previous field. Moves to the next field. Allows you to type in a value in the selected field (if applicable) or follow the link in the field. Expands or collapses a drop-down menu, if applicable. Moves to the next focus area. NOTE: For the standard graphics browser only. Moves to the previous page till you view the main screen. Pressing in the main screen displays a message that prompts you to save any unsaved changes and restarts the system. Displays the System Setup help file. NOTE: For most of the options, any changes that you make are recorded but do not take effect until you restart the system. System Setup options 76