Dell Force10 E600i Quick Start Guide - Page 17
E600i AC Power Modules, The 2500W AC Power Supply Unit is capable of operating at either 100 VAC or
View all Dell Force10 E600i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Step Task 8 Replace the safety cover and tighten the captive screw with a #2 Phillips screwdriver. 9 Turn the Over Current Protector to the ON position. 10 Turn the remote power source (the circuit breaker panel) to the ON position. E600i AC Power Modules The E600i requires a minimum of two AC Power Supplies. Power Supply Input Minimum (N) Redundancy 220 VAC 3 N+1 100 VAC 2 N+1 The chassis has four power supply slots. You may install AC power supplies in any slot. WARNING: Class 1 laser product. The 2500W AC Power Supply Unit is capable of operating at either 100 VAC or 220 VAC. CAUTION: Before removing and replacing a power supply unit, determine if the E600i is in full redundancy or non-redundant mode. Operating in nonredundant mode will require a complete system power off when removing and replacing a power supply. NOTE: Do not mix power supply versions. Installing a 2500W-AC2 power supply into a chassis with 2500W-AC power supplies already installed may result in unpredictable behavior. FTOS will declare an alarm when the PSUs are mixed. To install an AC power supply: Step Task 1 Verify that the power switch on the power supply is in the OFF position. 2 Orient the power supply handle to the left, and slide the backplane connector end into a power supply slot. Installing the Hardware 15