Dell Force10 S25N-S50N Installing S50N and S50V Systems - Page 36
Inserting an S50N PSU into the EPS
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
www.dell.com | support.dell.com continue, as above. Figure 5-12 on page 36 shows the typically-used screw hole locations circled in red. Figure 5-12. EPS Rear-Mounted (shown fully populated with PSUs) 3 Insert a PSU into a bay of the PSE so that the captive screws align with the screw holes in the PSE, and then tighten the screws. Figure 5-13. EPS Front-Mounted (shown below an S50) Inserting an S50N PSU into the EPS The Power Supply Unit (PSU) that supports both the S50 and S50N is an optional, external AC/DC rectifier that provides 180W DC at 48V. 36 | Installing Backup Power fn00155s50
36
|
Installing Backup Power
www.dell.com | support.dell.com
continue, as above.
Figure
5-
12 on page
36
shows the typically-used screw hole locations circled in
red.
Figure 5-12.
EPS Rear-Mounted (shown fully populated with PSUs)
3
Insert a PSU into a bay of the PSE so that the captive screws align with the screw holes in the PSE,
and then tighten the screws.
Figure 5-13.
EPS Front-Mounted (shown below an S50)
Inserting an S50N PSU into the EPS
The Power Supply Unit (PSU) that supports both the S50 and S50N is an optional, external AC/DC
rectifier that provides 180W DC at 48V.
fn00155s50