Dell Force10 S50-01-GE-48T FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 1074

www.dell.com | support.dell.com Related Commands - area encryption show crypto ipsec policy show crypto ipsec sa ipv6 Configure an IPsec encryption policy for an OSPFv3 area. Display the configuration of IPsec encryption policies. Display the security associations set up for OSPFv3 interfaces in encryption policies. ipv6 ospf cost c e Explicitly specify the cost of sending a packet on an inter. Syntax ipv6 ospf cost interface-cost To reset the interface cost to the default value, use the no ipv6 ospf cost interface-cost command. Parameters interface-cost Enter a unsigned integer value expressed as the link-state metric. Range: 1 to 65535 Defaults Default cost based on the bandwidth Command Modes INTERFACE Command History Version 7.8.1.0 Version 7.4.1.0 Added support for C-Series Introduced Usage Information In general, the path cost is calculated as: 10^8 / bandwidth Using this formula, the default path cost are calculated as: • GigabitEthernet-Default cost is 1 • TenGigabitEthernet-Default cost is 1 • Ethernet-Default cost is 10 ipv6 ospf dead-interval c e Set the time interval since the last hello-packet was received from a router. After the time interval elapses, the neighboring routers declare the router down. Syntax ipv6 ospf dead-interval seconds To return to the default time interval, use the no ipv6 ospf dead-interval command. Parameters seconds Enter the time interval in seconds. Range: 1 to 65535 seconds Default: 40 seconds (Ethernet) Defaults As above Command Modes INTERFACE 1074 | Open Shortest Path First (OSPFv2 and OSPFv3)