Dell Force10 S50-01-GE-48T FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 1539
dataplane-diag disable dfo-reporting, RPM1-P:CP %CHMGR-2-SFM_PCDFO: PCDFO error detected for SFM4
View all Dell Force10 S50-01-GE-48T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1539 highlights
Example Figure 66-1. show diag sfm command Example Force10#show diag sfm Switch Fabric Module Loopback Test: enabled SFM Walk-Through in Loopback Test: enabled SFM Bring-Down in Loopback Test: enabled Switch Fabric Module Loopback State: on -- Route Processor Modules -- Slot Test Status Last Result Time Stamp 0 off none 1 on pass Feb 16 2007 15:50:26 -- Line cards -- Slot Test Status Last Result Time Stamp 0 off none 1 off none 2 on pass Feb 16 2007 15:50:26 3 off none 4 on pass Feb 16 2007 15:50:26 5 off none 6 off none Force10# dataplane-diag disable dfo-reporting ex Disable the per-channel DFO (deskew FIFO overflow) reporting via event logging. Syntax dataplane-diag disable dfo-reporting To re-enable, use the no dataplane-diag disable dfo-reporting command. Defaults Command Modes Enabled CONFIGURATION Command History Version 8.1.1.2 Version 8.1.1.0 Introduced on E-Series ExaScale E600i Introduced on E-Series ExaScale E1200i Usage Information The per-channel DFO error reporting via event logging is enabled by default on TeraScale chassis. The error reporting issues a warning when a temporary dataplane glitch occurs or when a persistent malfunction is detected. When a DFO error is detected, no automatic action is initiated by the system. The message issued is similar to: %RPM1-P:CP %CHMGR-2-SFM_PCDFO: PCDFO error detected for SFM4 This command disables the per-channel DFO reporting. Related Commands diag sfm show diag sfm Initiate a manual dataplane loopback test. Display the loopback test results Note: This command is not supported on the E600i chassis. E-Series ExaScale Debugging and Diagnostics | 1539