Dell Force10 S50-01-GE-48T FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 616

www.dell.com | support.dell.com Usage Information If an IP address or VRRP group is assigned to the interface, you cannot use the switchport command on the interface. To use the switchport command on an interface, only the no ip address and no shutdown statements must be listed in the show config output. When you enter the switchport command, the interface is automatically added to the default VLAN. To use the switchport backup interface command on a port, you must first enter the switchport command. For details, see the Configuring Redundant Links section in the Layer 2 chapter of the FTOS Configuration Guide. Related Commands interface port-channel show interfaces switchport Create a port channel interface. Display information about switchport interfaces. wanport e Enable the WAN mode on a TenGigabitEthernet interface. Syntax wanport To disable the WAN Port, enter no wanport. Defaults Not configured. Command Modes CONFIGURATION Command History Version 8.1.1.2 pre-Version 6.2.1.0 Introduced on E-Series ExaScale Introduced for E-Series Usage The port must be in a shutdown state to change from LAN mode to WAN mode and vice-versa as Information shown in the figure below. For E-Series ExaScale systems, you must configure all the ports in a port-pipe to either WANPHY or non-WANPHY. They cannot be mixed on the same port-pipe. Example Figure 24-42. wanport Command with shutdown Command Example interface TenGigabitEthernet 13/0 no ip address no shutdown Force10(conf-if-te-13/0)# Force10(conf-if-te-13/0)#wanport % Error: Port should be in shutdown mode, config ignored Te 13/0. Force10(conf-if-te-13/0)# Force10(conf-if-te-13/0)#shutdown Force10(conf-if-te-13/0)# Force10(conf-if-te-13/0)#wanport Force10(conf-if-te-13/0)# Related Commands ais-shut alarm-report clock source down-when-looped flag Send LAIS on shutdown Enable reporting of a selected alarm Configure a clock source Send a message when a loopback condition is detected Set flags to ensure interoperability 616 | Interfaces