Dell Force10 S50-01-GE-48T FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 138

www.dell.com | support.dell.com E-Series Example Figure 5-52. Command Example: show rpm on E-Series Force10#show RPM 0 -- RPM card 0 -- Status : active Next Boot : online Card Type : RPM - Route Processor Module (LC-EF-RPM) Hardware Rev : 2.0 Num Ports : 1 Up Time : 36 min, 51 sec Last Restart : reset FTOS Version : 6.2.1.0 Jumbo Capable : yes CP Boot Flash : A: 2.4.0.6 B: 2.4.0.7 [booted] RP1 Boot Flash: A: 2.4.0.7 [booted] B: 2.4.0.5 RP2 Boot Flash: A: 2.4.0.7 [booted] B: 2.4.0.5 CP Mem Size : 536870912 bytes RP1 Mem Size : 0 bytes RP2 Mem Size : 0 bytes Temperature : 49C Power Status : PEM0: absent or down PEM1: up Voltage : ok Serial Number : 0016788 Part Number : 7520013800 Rev 01 Vendor Id : 01 Date Code : 06182004 Country Code : 01 Force10# Table 5-7 defines the fields displayed in Figure 5-52. Table 5-7. Descriptions of show rpm output Field Status Next Boot Card Type Hardware Rev Num Ports Up Time Last Restart FTOS Version Jumbo Capable Description Displays the RPM's status. Displays whether the RPM is to be brought online at the next system reload. Displays the RPM catalog number. Displays theE-Series chipset hardware revision level: 1.0 (non-Jumbo); 1.5 (Jumbo-enabled); 2.0 (or above is TeraScale). Displays the number of active ports. Displays the number of hours and minutes since the RPM's last reboot. States the reason for the last RPM reboot. C-Series possible values: • "normal power-cycle" (reset power-cycle command) • "reset by master" (peer RPM reset by master RPM) • "over temperature shutdown" • "power supply failed" E-Series possible values: • "normal power-cycle" (insufficient power, normal power cycle) • "reset by user" (automatic failover, software reload of both RPMs, or master RPM resetting peer) • "force-failover" (redundancy force-failover command) Displays the operating software version. Displays a Yes or No indicating if the RPM is capable of sending and receiving Jumbo frames. This field does not indicate if the chassis is in Jumbo mode; for that determination, use the show chassis brief command. 138 | Control and Monitoring