Dell Force10 S50-01-GE-48T FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 1153
Command Example: Configuring a Source Port, Command Modes, Command, History, Example
View all Dell Force10 S50-01-GE-48T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1153 highlights
Command Modes Command History Example MONITOR SESSION (conf-mon-sess-session-ID) Version 8.4.1.2 Introduced on the E-Series ExaScale. Figure 45-5. Command Example: Configuring a Source Port Force10(conf-mon-sess-11)#source gigabitethernet 10/0 destination remote-vlan 2 direction rx Force10(conf-mon-sess-11)# Usage Information You can configure physical ports, port-channels, and VLANs as sources in remote port mirroring and use them in the same source session. You can use both Layer 2 (configured with the switchport command) and Layer 3 ports as source ports. In remote port mirroring: • Up to 4 source sessions are supported on a switch. • Up to 128 source ports are supported in a source session. When you configure a port channel or VLAN in a source session, all ports in the port channel or VLAN are used as source ports, up to a maximum of 128 source ports. You can configure trunk ports and access ports as source ports. You can configure trunk ports and non-trunk ports as source ports in a remote-port mirroring session. You can use the default VLAN and native VLANs as a source VLAN. You cannot configure the dedicated VLAN used to transport mirrored traffic as a source VLAN. A destination port for remote port mirroring cannot be used as a source port, including the session in which the port functions as the destination port. A source port channel or source VLAN, which has a member port that is configured as a destination port, cannot be used as a source port channel or source VLAN. You can use ACLs on a source port. In a flow-based source session, packets sent from the RPM are not monitored. Rate-limiting tagged-VLAN egress traffic on a source port is supported. To delete one or more monitored ports from a source session, enter the complete no source (remote port mirroring) command. The dedicated L2 VLAN used for remote port mirroring is configured with the mode remote-port-mirroring command. To change the reserved VLAN used in a source session, you can remove the current VLAN by entering the no source destination vlan vlan-id command. Then re-enter the complete source (remote port mirroring) command as described above to configure a new reserved VLAN for the source session. Port Monitoring | 1153