Dell Force10 S50-01-GE-48T FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 504

www.dell.com | support.dell.com domain-name c e Specify the domain name for the Administrator's email address. Syntax domain-name domain_name To remove the domain name, use the no domain-name command. Parameters domain name Enter the keyword domain-name followed by the complete domain name of the Administrator's email address, for example, domain_name.com. Defaults The domain name specified in the admin-email command Command Modes CONFIGURATION (conf-callhome) Command History Version 7.6.1.0 Version 6.3.1.0 Introduced on C-Series Introduced for E-Series Usage If you use this command to specify a domain name, that domain name is used instead of any domain Information name that you might have specified using the admin-email command. Related Commands admin-email call-home Enter the Administrator's email address. Start FTSA and Enter the FTSA mode. enable c e Enable the sending of FTSA email messages to the selected recipient. Syntax enable To disable (end) the sending of FTSA email messages to the selected recipient, use the no enable command. Defaults no enable Command Modes conf-callhome Command History Version 7.6.1.0 Version 6.3.1.0 Introduced on C-Series Introduced for E-Series Usage Information If you leave the selected recipient in the default condition of disabled (no FTSA email messages to the selected recipient), you can either come back to this command later, or you can use the enable-all command. If you use the enable-all command, you can then disable email messages to the recipient with the no enable command at the server-specific prompt. FTSA sends an email notification to the selected recipient whenever the enable status changes. Note: Execute the enable command only after the SMTP and admin-email commands are executed. 504 | Force10 Service Agent