Dell Force10 S50-01-GE-48T FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 1545

Example Figure 66-5. show command-history orce10#show command-history 15 [1/15 14:59:27]: CMD-(CLI):[enable]by default from console [1/15 15:9:15]: CMD-(CLI):[show linecard all]by default from console [1/15 15:9:28]: CMD-(CLI):[interface gigabitethernet 12/0]by default from console [1/15 15:11:51]: CMD-(CLI):[show startup-config]by default from console [1/15 15:24:24]: CMD-(TEL46):[enable]by admin from vty0 (peer RPM) [1/15 15:24:39]: CMD-(TEL46):[show version]by admin from vty0 (peer RPM) [1/15 15:25:23]: CMD-(TEL46):[show interfaces managementethernet 1]by admin from vty0 (peer RPM) [1/15 15:25:45]: CMD-(CLI):[configure]by default from console - Repeated 1 time. [1/15 15:25:56]: CMD-(CLI):[username mari password ******]by default from console [1/15 15:26:33]: CMD-(CLI):[configure]by default from console - Repeated 1 time. [1/15 15:26:47]: CMD-(CLI):[ip ssh server enable]by default from console [1/15 15:26:59]: CMD-(SSH47):[enable]by mari from vty0 (10.11.9.207) [1/15 15:27:8]: CMD-(SSH47):[show command-history 15]by mari from vty0 (10.11.9.207) Force10# Usage Information The command history output includes: • [username name password *******] -when the command is executed via telnet • [by default from console] -when the command is executed via console • [by admin from vty0 (peer RPM)] -with brackets, when the command is executed to primary rpm via standby rpm using telnet-peer-rpm command. Each command contains up to 50 characters in the display output. FTOS compares the first 50 characters of each command and if the characters are the same (i.e. the same command was issued), then the display output indicates the duplicate entry with "Repeated X times". All commands executed by all users, except password related commands, are captured in the trace command history log. Each command has a date and time stamp. The trace-log file has a separate 3000 line buffer to hold command history on a FIFO basis. When the buffer is full, the contents wraps (i.e. the first line is automatically deleted to make room for the last command line).This file can be analyzed by the Dell Force10 Technical Assistance Center (TAC) to assist in troubleshooting. Note: No password information is saved to the trace command history log. show console ex Display, onto the console, background resets, calls, initialization etc. of the designated line card. Syntax show console lp slot-number Parameters lp slot-number (OPTIONAL) Enter the keyword lp and the slot number to view information on the line-card processor in that slot. Range: 0 to 13 on a E1200, 0 to 6 on a E600/E600i, and 0 to 5 on a E300. Defaults No default behavior or values Command Modes EXEC Privilege E-Series ExaScale Debugging and Diagnostics | 1545