Dell Inspiron N5010 Service Manual - Page 18

Back to Contents Page Display Dell™ Inspiron™ N5010/M5010 Service Manual Display Assembly Display Bezel Display Panel WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance. CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty. CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on your computer). CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the computer. Display Assembly Removing the Display Assembly 1. Follow the instructions in Before You Begin. 2. Remove the battery (see Removing the Battery). 3. Remove the base cover (see Removing the Base Cover). 4. Remove memory module(s) (see Removing the Memory Module(s)). 5. Remove the optical drive (see Removing the Optical Drive). 6. Remove the keyboard (see Removing the Keyboard). 7. Remove the palm rest (see Removing the Palm Rest). 8. Turn the computer over and remove the two screws. 9. Disconnect the Mini-Card antenna cables from the Mini-Card. 10. Disconnect the display cable from the connector on the system board and remove it from the routing guide. 11. Remove the four screws (two on each side) that secure the display assembly to the computer base. 12. Lift and remove the display assembly out of the computer base.