Dell Inspiron N5010 Service Manual - Page 19

Display Bezel

Get Dell Inspiron N5010 PDF manuals and user guides View all Dell Inspiron N5010 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

1 screws (4) 3 Mini-Card antenna cables 2 display cable 4 display assembly Replacing the Display Assembly 1. Follow the instructions in Before You Begin. 2. Place the display assembly in position and replace the four screws (two on each side) that secure the display assembly to the computer base. 3. Route the display cable into the routing guide and connect the cable to the connector on the system board. 4. Connect the Mini-Card antenna cables to the connectors on the Mini- Card. 5. Turn the computer over and replace the two screws at the bottom of the computer. 6. Replace the palm rest (see Replacing the Palm Rest). 7. Replace the keyboard (see Replacing the Keyboard). 8. Replace the optical drive (see Replacing the Optical Drive). 9. Replace memory module(s) (see Replacing the Memory Module(s)). 10. Replace the base cover (see Replacing the Base Cover). 11. Replace the battery (see Replacing the Battery). CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in damage to the computer. Display Bezel Removing the Display Bezel CAUTION: The display bezel is extremely fragile. Be careful when removing it to prevent damaging the bezel. 1. Follow the instructions in Before You Begin.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
Replacing the Display Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Place the display assembly in position and replace the four screws (two on each side) that secure the display assembly to the computer base.
3.
Route the display cable into the routing guide and connect the cable to the connector on the system board.
4.
Connect the Mini-Card antenna cables to the connectors on the Mini- Card.
5.
Turn the computer over and replace the two screws at the bottom of the computer.
6.
Replace the palm rest (see
Replacing the Palm Rest
).
7.
Replace the keyboard (see
Replacing the Keyboard
).
8.
Replace the optical drive (see
Replacing the Optical Drive
).
9.
Replace memory module(s) (see
Replacing the Memory Module(s)
).
10.
Replace the base cover (see
Replacing the Base Cover
).
11.
Replace the battery (see
Replacing the Battery
).
Display Bezel
Removing the Display Bezel
1.
Follow the instructions in
Before You Begin
.
1
screws (4)
2
display cable
3
Mini-Card antenna cables
4
display assembly
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
CAUTION:
The display bezel is extremely fragile. Be careful when removing it to prevent damaging the bezel.