Dell Latitude 7212 Rugged Extreme Tablet Latitude 12 Rugged Extreme Tablet - 7 - Page 20
Installing display assembly
View all Dell Latitude 7212 Rugged Extreme Tablet manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
NOTE: DO NOT remove any cable or adhesive tape from the display panel, unless you are replacing the cables separately. Installing display assembly 1 Place the system chassis on a plane surface. 2 Place the bottom edge of the display assembly inside the bottom edge of the rear chassis. 3 Rest the display assembly by less than 90° angle. NOTE: Use a support to attain the required angle. 4 Connect the touch cable, function keys cable, and LVDS cable to the connector on the system board. 5 Release the latch to secure the cables to the respective connecting ports. NOTE: Make sure to insert the cable under the clips, if not, the system may not display video after reassembling. 6 Paste the adhesive tapes to secure the connected slots. NOTE: Ensure to secure the adhesive tapes, to protect the display assembly from electrostatic discharge damage. 7 Align the display assembly on the tablet chassis and press the edges to snap-in. NOTE: • Ensure that the Window button on the display assembly aligns with the docking pogo pins on the system board chassis. • Press the edges starting from Windows button clockwise until they snap-in evenly from all sides. Ensure to hear a click sound when the display assembly is aligned in correct position. 8 Flip the system so that the battery is at top view. NOTE: Ensure to place the system in a flat surface. 9 Replace the screws (19) to secure the display assembly to the tablet. NOTE: DO NOT tighten the screws too much, to avoid damage the screws thread. 10 Install the: a Battery 20 Removing and installing components