Dell Latitude 7230 Rugged Extreme Tablet Service Manual - Page 68
Installing the fan with SSD heat-sink
View all Dell Latitude 7230 Rugged Extreme Tablet manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Steps 1. Disconnect the fan cable from the connector on the system board. 2. Unroute the fan cable from the routing guides along the right-side of the system-board shielding cover. 3. Remove the two screws (M2x5) that secure the fan to the tablet. 4. Remove the three screws (M2x2) that secure the SSD heat-sink to the system board. 5. Lift the fan with SSD heat-sink away from the tablet. Installing the fan with SSD heat-sink Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The figure indicates the location of the fan with SSD heat-sink and provides a visual representation of the installation procedure. 68 Removing and installing components
Steps
1.
Disconnect the fan cable from the connector on the system board.
2.
Unroute the fan cable from the routing guides along the right-side of the system-board shielding cover.
3.
Remove the two screws (M2x5) that secure the fan to the tablet.
4.
Remove the three screws (M2x2) that secure the SSD heat-sink to the system board.
5.
Lift the fan with SSD heat-sink away from the tablet.
Installing the fan with SSD heat-sink
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the fan with SSD heat-sink and provides a visual representation of the installation procedure.
68
Removing and installing components