Dell Latitude 7230 Rugged Extreme Tablet Service Manual - Page 78
for models shipped with WWAN antennas., for the models shipped with a handle.
View all Dell Latitude 7230 Rugged Extreme Tablet manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
Steps 1. Place the tablet on a flat and clean surface. 2. For models shipped with a Mini-serial RS232 port, replace the four hexagonal Mini-serial RS232 FPC standoff nuts on the display-panel assembly. NOTE: The four hexagonal Mini-serial RS232 FPC standoff nuts that are removed from the faulty display-panel assembly must be replaced in the replacement display-panel assembly. 3. For models shipped with a Mini-serial RS232 port or RJ45 port, align the screw hole on the Mini-serial RS232/RJ45 bezel with the screw on the display-panel assembly. 4. Replace the single screw (M2x2) to secure the Mini-serial RS232/RJ45 bezel to the display-panel assembly. Next steps 1. Install the system board. 2. Install the fan with SSD heat-sink assembly. 3. Install the front camera and microphone assembly. 4. Install the scanner assembly. 5. Install the heat sink. 6. Install the world-facing camera. 7. Install the USB daughter-board, Mini-serial RS232 daughter-board, RJ45 daughter-board, and decoder daughter-board. 8. Install the USB-port assembly, Mini-serial RS232 port assembly, RJ45-port assembly, or blank top-cover. 9. Install the USB/HDMI port. 10. Install the I/O daughter-board. 11. Install the WWAN card (for models shipped WWAN card). 12. Install the wireless card. 13. Install the M.2 2230 solid-state drive. 14. Install the back-cover assembly. 15. Install the SIM card (for models shipped with WWAN antennas). 16. Install the batteries. 17. Install the handle (for the models shipped with a handle). 18. Install the stylus. 19. Follow the procedure in after working inside your tablet. 78 Removing and installing components